Show simple item record

dc.contributor.authorCaballero, E.S.
dc.contributor.authorTernero Fernández, Fátima
dc.contributor.authorUrban, P.
dc.contributor.authorGómez Cuevas, Francisco Paula 
dc.contributor.authorCintas, J.
dc.date.accessioned2020-06-19T09:16:35Z
dc.date.available2020-06-19T09:16:35Z
dc.date.issued2020-06
dc.identifier.citationCaballero, E. S., Ternero Fernández, F., Urban, P., Gómez Cuevas, F. & Cintas, J. (2020). Influence of Temperature on Mechanical Properties of AMCs. Metals, 10(6), 783. DOI: https://doi.org/10.3390/met10060783es_ES
dc.identifier.issn2075-4701
dc.identifier.urihttp://hdl.handle.net/10272/18348
dc.description.abstractThis research focused on studying the effect of temperature on the mechanical properties of aluminium matrix composites (AMCs) obtained by a powder metallurgy route. Aluminium powder was milled at room temperature for 5 h and using different atmospheres in order to achieve different amounts of reinforcement. The atmospheres employed were vacuum, confined ammonia, and vacuum combined with a short-time (5 and 10 min) of ammonia gas flow. After mechanical alloying, powders were consolidated by cold uniaxial pressing (850 MPa) and vacuum sintering (650 °C, 1 h). Hardness and tensile tests, on consolidated samples, were carried out at room temperature. Subsequently, the effect of temperature on both properties were evaluated. On one hand, the UTS and hardness were measured, again at room temperature, but after having subjected the sintered samples to a prolonged annealing (400 °C, 100 h). On the other hand, the tensile and hardness behaviour were also studied, while the samples are at high temperature, in particular 250 °C for UTS, and in the range between 100 and 400 °C for hardness. Results show that the use of ammonia gas allows achieving mechanical properties, at room and high temperature, higher than those of the commercial alloys EN AW 2024 T4, and EN AW 7075 T6.es_ES
dc.language.isoenges_ES
dc.publisherMDPIes_ES
dc.relation.isversionofPublisher’s versión
dc.rightsAtribución-NoComercial-SinDerivadas 3.0 España*
dc.rights.urihttp://creativecommons.org/licenses/by-nc-nd/3.0/es/*
dc.subject.otherAMCses_ES
dc.subject.otherMechanical alloyinges_ES
dc.subject.otherMechanical propertieses_ES
dc.subject.otherTemperaturees_ES
dc.titleInfluence of Temperature on Mechanical Properties of AMCses_ES
dc.typeinfo:eu-repo/semantics/articlees_ES
dc.identifier.doi10.3390/met10060783
dc.rights.accessRightsinfo:eu-repo/semantics/openAccesses_ES


Files in this item

This item appears in the following Collection(s)

Show simple item record

Atribución-NoComercial-SinDerivadas 3.0 España
Except where otherwise noted, this item's license is described as Atribución-NoComercial-SinDerivadas 3.0 España

Copyright © 2008-2010. ARIAS MONTANO. Repositorio Institucional de la Universidad de Huelva
Contact Us | Send Feedback |