Show simple item record

dc.contributor.authorCaballero, E. S.
dc.contributor.authorGómez Cuevas, Francisco Paula 
dc.contributor.authorTernero, Fátima
dc.contributor.authorAstacio, R.
dc.contributor.authorMontes Martos, Juan Manuel
dc.contributor.authorCintas, J.
dc.date.accessioned2018-05-24T09:34:17Z
dc.date.available2018-05-24T09:34:17Z
dc.date.issued2018
dc.identifier.citationCaballero, E. S. Gómez Cuevas, Francisco Paula Ternero, Fátima Astacio, R. Montes Martos, Juan Manuel Cintas, J.: "In Situ Synthesis of Al-Based MMCs Reinforced with AlN by Mechanical Alloying under NH3 Gas". Materials. Vol. 11(5), 823; https://doi.org/10.3390/ma11050823es_ES
dc.identifier.issn1996-1944
dc.identifier.urihttp://hdl.handle.net/10272/14792
dc.description.abstractAluminum matrix composites (AMCs) reinforced by aluminum nitride were prepared by mechanical alloying followed by a simple press and sintering method. Milling began under vacuum and after a period of between 1 and 4 h, NH3 gas flow (1 cm3/s) was incorporated until the total milling time of 5 h was reached. Results show that in addition to the strain hardening taking place during mechanical alloying, NH3 plays an additional role in powder hardening. Thereby, the properties of the sintered compacts are strongly influenced by the amount of N incorporated into the powders during milling and the subsequent formation of AlN during the consolidation process. The obtained AMC reaches tensile strengths as high as 459 MPa and hardness much higher than that of the as-received aluminum compact.es_ES
dc.description.sponsorshipFinancial support of the Ministerio de Economia y Competitividad (MINECO/FEDER, Spain) through the research project DPI2015-69550-C2-1-P is gratefully acknowledged.es_ES
dc.language.isoenges_ES
dc.publisherMDPIes_ES
dc.rightsAtribución-NoComercial-SinDerivadas 3.0 España*
dc.rights.urihttp://creativecommons.org/licenses/by-nc-nd/3.0/es/*
dc.subject.otherAluminumes_ES
dc.subject.otherAMCses_ES
dc.subject.otherPowdermetallurgyes_ES
dc.subject.otherMechanochemical processinges_ES
dc.subject.otherMechanical propertieses_ES
dc.titleIn Situ Synthesis of Al-Based MMCs Reinforced with AlN by Mechanical Alloying under NH3 Gases_ES
dc.typeinfo:eu-repo/semantics/articlees_ES
dc.identifier.doi10.3390/ma11050823
dc.rights.accessRightsinfo:eu-repo/semantics/openAccesses_ES
dc.relation.projectIDinfo:eu-repo/grantAgreement/Ministerio de Economía y Competitividad (MINECO/FEDER, Spain) [DPI2015-69550-C2-1-P]es_ES


Files in this item

This item appears in the following Collection(s)

Show simple item record

Atribución-NoComercial-SinDerivadas 3.0 España
Except where otherwise noted, this item's license is described as Atribución-NoComercial-SinDerivadas 3.0 España

Copyright © 2008-2010. ARIAS MONTANO. Repositorio Institucional de la Universidad de Huelva
Contact Us | Send Feedback |